This is the Stoked.Design replacement foot for 57cm Weber Kettles.
 
This foot is to replace the standard rubber bungs as they wear thru.
These new feet provide a larger surface area so the leg doesnt sink into the grass
 
 
         3D Printed using Black ASA plastic - UV Stable for exterior applications!
 
         Tight slide on fit, 25.5mm bore allowing 0.1mm clearance on the 1" aluminium tube - may require slight persuasion depending on the roundness of your existing leg, cooking oil is a good lubricant.
 
         NOTE check your existing leg and debur as necessary. - if this foot is not a tight slide fit, Use a timber block between the new foot and your hammer, do not hit the plastic foot directly with your hammer
 
As these are 3D printed, naturally these may have very minor visible layer lines from the manufacturing process.